ICE is gone!

My buddy Tom came over and helped me pull the internal combustion engine out of the S-10. It took a lot longer than I expected but we finally accomplished our goal. The service manual suggests disconnecting the engine and the transmission and then pulling the engine. However, for the life of us we couldn't figure out how to get the bolts off that where holding them together. There was barely clearance to get your finger over the bolt let alone a wrench or socket. We ended up just pulling the engine and transmission out together. The key to it all was to lift the motor enough to get to the engine mount bolts and then remove the engine mounts. Once those were out of the way we were able to shimmy it out slowly.

The ICE before the surgery ;)

Tom under the mid-section of the car removing the transmission support. Had he put down the cigurette maybe he wouldn't have dropped my 1/2 inch socket into the frame, thanks Tom ;). [Update: was able to retrieve the socket after purchasing a automotive magnet pickup tool]
Starter, drive shaft, and transmission support all needed to come out before we started pulling engine.Taken before one of our many attempts at pulling the engine.

We placed the floor jack inline with the transmission so we could control the transmission height as we pulled with the engine hoist.

One of our failed attempts at getting it out, I know this because engine mount is still installed here.

Tom giving me his, "I am too tired for this s***" look.Finally! it came out. The key was removing the engine mounts from the frame so we had the needed clearance.


What a mess! I should have done a better job draining the transmission before all of this.Temporarily supported engine and transmission on jacks. I am going to build a simple support out of wood so I can reclaim the jacks, definitely going to need those for the rest of the work.